Steps for RFC destination in TMS

[Former Member]

Hi ,

I need to configure a transport system , First I need to set RFC destination.

I need to do a two system landscape. I need to set RFC destination for tis two systems only .

Is that I need to set a RFC destination(t-code SM59) in DEV as

DEV-DEV (DEV IP address)

DEV-PRD (PRD IP address)

In PRD as follows

PRD-PRD (PRD IP address)

PRD-DEV (DEV IP address)

I know we have to set a path :

DEV-DEV

DEV-PRD

PRD-PRD

PRD-DEV

as RFC Destinations, but where i need to set tis either in DEV or in PRD is my doubt.

In which client i need to login , for tis RFC destination creation . Is that i need to login in 000 client.

If i m wrong please correct me please..

Regards,

Hari

[Former Member]

In a very simple terms

Yes! You have to login to client 000 for tme configuration.

1.you have to create the transport domain.<PRD>

2.Go to Dev and QA and run stms and add these systems to transport domain.

3.Again login to transport domain <PRD> and accept the system into the transport domain.

4.Later you can go to the graphical tool in transport domain and configure the transport route .

Dev-qa consolidation

qa to prd -delivery

and then distribute the configuration.

You dont need to worry about the rfc etc.It is automatic process.

Good Luck.

Amit

[Former Member]

Hello Haren,

Check out this link. about STMS Configuration.

http://www.sap-img.com/basis/how-to-do-the-tms-configuration.htm

Regards,

Prashant P.

[Former Member]

Hi,

While configuring STMS it will create the rfc's for you we dont create any rfc manually.

Regards,

Vamshi.

[Former Member]

Hi ,

We need to set IP address path for each and every system . I m asking about the Ip address setting path of each system .

Regards,

Hari