on 08-06-2008 3:49 AM
Hi,
I am trying to map a keyfigure to a Category/Category Group. However when I am in the change mode in the Planning area, both Category/Category Group columns are displayed as read only. I had even tried by removing te Time Series objects. even then these columns are non readable.
How do i make these columns readable ? any ideas / thoughts?
TIA
If the keyfigure is a TimeSeries keyfigure you cannot assign a Category / Category Group.
Check the Semantic of the keyfigure in the Planning Area deasign view.
Semantic of 000 is a Orderseries (LC: Qty) keyfigure which can be assigned with Category / Category Group.
Somnath
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please explain your issue in more detail. Will try and help.
Linking a KeyFigure in Planning area to a Category Group should not have the effect you are talking about. Please check if you did something wrong. Refer to the Setup of 9ASNP02 Planning area on how KFs and Category Groups are linked and then also see the same KF appearing in 9ASNP94 Planning Book in SNP Interactive Planning.
If this is helpfull Please_award_points.
Regards,
Ambrish Mathur
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
8 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.