cancel
Showing results for 
Search instead for 
Did you mean: 

Why Class characteristics req in QM

Former Member
0 Kudos

Hi QM Gurus,

I have inspection plan with MIC it is working very well.

But some of them told you can use class characteristics with MIC.

My question is.

1. What is the use of class characteristics?

2. why it is assign to MIC.

Please clarify....

Regards,

Babu.S

Accepted Solutions (0)

Answers (2)

Answers (2)

Former Member
0 Kudos

Good One

Former Member
0 Kudos

Dear Singh,

>1. What is the use of class characteristics?

It migrates the results recorded to the Batch Class.

>2. why it is assign to MIC.

Class Characteristic is assign to...

- 1. Batch Class, and this batch class is assigned to Material

- 2. With reference to this Class Characteristic, an MIC is created, and this MIC is getting assigned to the Inspection Plan/ Material Specification of the Material.

- Now when the RR is done for these MIC, in the inspection lot for the Material, the Values of Result, Migrates to the Batch, in the Batch Class.

To test the scenario

- Create a Characteristic (CT04)

- Create a Batch Class (CL02)

- Assign the Characteristic to the Batch Class.

- Assign the Batch Class to Material.

- Create an MIC, using the Characteristic (QS21)

- Assign the MIC to the Inspection Plan (QP01)/ Material Specification (QS61), of the Material.

- Create an Inspection Lot for the Material, have new Batch.

- Perform RR and UD.

- Now go to MMBE,MM02,BMBC,MSC3N, and check the value of the Result is Migrated here in the Batch, under Batch Class.

NOTE:-. It will not work if the material is not Batch Managed.

Let me know the progress.

Have Happy Week End!!!!!!!!

Regards,

Shyamal

Former Member
0 Kudos

Hi Shyamal Joshi ,

For each character i need to create each class or i can use single class to many characters please confirm.

Regards,

Babusingh.s

Former Member
0 Kudos

You can keep signal Class. Depends up on the number of Characteristic you need to assign. If it is huge in numbers (like 40-50 to MM) Then you should create Classes Material Type Wise to filter the un-necessary Characteristics not relevant to the M.Type

Regards,

Shyamal

Edited by: Shyamal Joshi on Aug 5, 2008 10:52 AM