status profile for the selection screen ?

[former_member192718]

Dear Shymal,

The link of thread which you sent have this line status profile for the selection screen for QA33 and QA32 . I don't users ti get those lots which are having status LTCA.

Now how can i do this? Can you explain me?

Regards,

Kaushal Rai

[Former Member · Accepted solution]

Dear Kaushal,

It is written in that reply status profile, is just a slip of mind/Fingers only. We can say a typographical error. I hearty apologies for the same.

Now a accept my regret and pls find the rectification herewith.

That is "Selection Profile", to create rather I can say configure it,

- Run trx BS42, create new profile, Name it Logically.

- Double click on the "_Selection Conditions_",system will lead you to the screen named Change View "Selection Conditions": Over View.

- Here Enter the LTCA, in the Fourth Column "STATUS".

- Click on the check box under Sixth column 'not'.

The settings should be as.....

1st Column,,,Link :- No Links (Blank0

2nd Column,,,Usr:- Don't check this box.

3rd Column,,,St.Prof.:- Blank

4th Column,,,Status:- LTCA.

5th Column,,,Status:- Lot canceled

6th Column,,,not:- Check this box.

7th Column,,,Status:- It will be 'Active' by default.

Now SAVE.....

Now in QA32, pick the section profile you just created.

Let me know if it don't work.

Regards,

Shyamal

[former_member192718 · Accepted solution]

Dear Shyamal,

I would have given hundred points point system is not allowing. Actually I am PM certified consultant but looking both module these days.

Thanx for your kind help.

Regards,

Kaushal Rai

[Former Member · Accepted solution]

Dear Kaushal,

Thanks for the appreciation. I will always try to input my best.

Wish you lovely week end.

Regards,

Shyamal