Getting Error return Code :0152 when importing through CHARM (Urgent...)

[Former Member]

Hi All

we are facing an issue and details of the problem are:

1.created and urgent correction(SDHF)

2.created a transport Request under this urgent Correction Through CHARm in satellite Development system(D11) using the action "create TR"

3.developer logs in make changes ,saves them under the TR created through the CHARM and releases the Respective Task of the Transport request

4.Then TR is released from Solman using the action "releae TR"

5.now import of the TR is done to quality system(Q11) through CHARm("using action pass correction to test")

6.after doing all approvals, to import the TR to Production system ,the action "import correction to production" (P11) is set which should import the TR from Q11 to p11 but

it's throwing an error in urgen correction as below

"Unable to successfully complete import into production system"

and in import monitor of P11 the error is

07/08/2008 13:50:39 P11 U0

Last Activity:07/08/2008 13:50:39

target Client = Source client

maximum return Code:0152 -tp ended

Nothing Done

NOTE: imports are happening through Normal STMS

helpful answers rewarded

Regards,

Anand

[Former Member]

Hi Anand,

I suggest you to check the RFC destinations to the Production system. Then try importing again into the Production.

Hope this is helpful.

Regards,

Satish.

[Former Member]

HI satish,

thanks for your reply,but all the RFC connection are already checked many times and are working fine.

for your information from the probelm confirms that CHARM is triggering import in my production system but with error.so if any issue with RFC then it would not have started th imprt process

Rgds,

Anand

Edited by: Ananda Reddy Madithati on Jul 31, 2008 9:22 AM

Edited by: Ananda Reddy Madithati on Aug 1, 2008 1:55 PM

[Former Member]

Hi Anand,

I understand that you are getting maximum return Code:0152 -tp when you try to import into produciton using CHARM. However, the mentioned return code states that the possible issue is with the Transport tool and route.

I suggest you to check by importing the tp req. using STMS.

Please use the following link to find more info on this.

http://help.sap.com/saphelp_nw04/helpdata/en/7e/c6c2ad98a711d2b429006094b9ea64/content.htm

You can find the information about the same return code in the above link.

I hope this is helpful.

Regards,

Satish.

[Former Member]

HI satish,

i have alredy tried this,but no luck

regards,

Anand

Edited by: Ananda Reddy Madithati on Aug 4, 2008 10:17 AM