on 07-22-2008 2:18 PM
I have newly installed SAP system on windows platform successfully. I am doing post-steps now...
As per SAP note 88416 - Zero administration memory management as of 4.0A/ Windows
I want to change PHYS_MEMSIZE parameter, but note says 1st delete below parameters...
em/initial_size_MB
em/max_size_MB
em/address_space_MB etc....
this parameters are not available in profile files (instance, Default).
But is shows value in RZ11.
As per SAP Note 31395- few parameters are present in the coding.
So what is procedure to delete em/initial_size_MB parameter??
i tried from RZ10, its not deleting...
plz advise
Thank you
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Or to put it another way, you need to delete the memory parameter values, not the memory parameters themselves. If you leave them blank, SAP will assign the value as appropriate for your memory management scheme which is what you want.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Don't worry about RZ11. Just make sure you haven't set the parameters in the profiles (RZ10).
Michael
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
11 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.