Webservice setup

[Former Member]

Hi,

May I know what all necessary setup needs to be done for webservice scenario for PI 7.1.

Issue: Created a SOAP -> XI -> JDBC scenario. There is no issue with the Receiver side, but in RWB the SOAP sender communication channel is inactive. Do we need to do any webservice setup in /nwa because the communication channel is active in Integration Directory.

Please share your inputs.

Sundari

[Former Member · Accepted solution]

Hi,

The nature of SOAP is inactive...

once you post a message then it gets into active state....

<removed by moderator>

Thanks,

Mahdu

Edited by: Madhu sudhan Reddy on Jul 22, 2008 11:56 AM

Edited by: Mike Pokraka on Jul 24, 2008 1:06 PM

[former_member182455]

Hi

just post the dummy request after that check the status

looks the URL is wrong, check the URL u specified in the Reciever SOAP adapter.

You could find this URL(end point) in the wsdl of the webservice yo u are trying to call.

also take a look at the default.trc log file from visual administrator-> server

-> services -> log viewer -> locations -> com -> aii -> bc -> soap

Regards

sreddy

[Former Member]

After executing the scenario also, getting the same status in RWB. PI 7.1 is newly installed server and just started with the webservice scenarios.

Sundari

[Former Member]

Hi,

Please refer similar thread:

[SOAP Adapter Started but not active|;

Regards

Bhanu.

[Former Member]

hi

just post the dummy request after that check the status

Walkthrough - SOAP <-> XI <-> RFC/BAPI

<removed by moderator>

regards

kummari

Edited by: Mike Pokraka on Jul 24, 2008 1:06 PM

[Former Member]

Hi,

>>but in RWB the SOAP sender communication channel is inactive. Do we need to do any webservice setup in /nwa because the communication channel is active

The default behaviour of the SOAP Adapter is like that only,

Once you post any data through this adapter, this will turn active

that is not an Error

Regards

Seshagiri