on 07-21-2008 9:52 AM
Hello,
I have a setup in which IDoc flows from R/3 to XI to destination through HTTP. Being Async to Sync a BPM is put in place. This flow runs fine.
We tried adding one more receiver to the existing setup. The sender is the same as in the above mentioned flow. The receiver determination is failing. A separate receiver determination was configured for the second flow. The error message is "NO_RECEIVER_CASE_BE". We checked the entire configuration settings. Everything appears fine. Why is the receiver determination failing ? None of the solutions existing provides an answer that works. Any clues ?
Early answers would be much appreciated.
Thanks in advance.
Warm Regards,
IS / Siva
Instead of adding a spearate receiver determination, add an additional receiver to the existing one with no conditions. Automatically your messages will be sent to both of the reciever. Also you need to create interface determination and receiver agreements for this new receiver.
VJ
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
In the same receiver determination, with no condition, just add an additional receiver. Create interface determination and receiver agreement for the corresponding receiver. Activate all objects and try again with your input.
Hope this works..
Regards,
Parvathy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
specify the receiver in the existing RD and create another Interface determination adn receiver agreement to this receiver.
Thanks,
Madhu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.