Materials replication from R/3

[Former Member]

Hi guys

I am trying to replicate materials from R/3 into SRM and getting the following errors at smw01 , when checking in R3AM1 it shows the report as ran successfull , please help

Mat. for Initial Download: Table not supported by function

Conversion factors of base units of measure set to 1

Specify the relevant unit of length

Net weight of product 1000200 is larger than gross weight

Specify the relevant unit of weight

Data cannot be maintained for set type COMM_PR_UNIT

Data cannot be maintained for set type COMM_PR_SHTEXT

[Former Member]

We applied applied note 720819 to solve the errors

Conversion factors of base units of measure set to 1

Specify the relevant unit of length

Net weight of product 1000200 is larger than gross weight

Specify the relevant unit of weight

[Former Member]

Hi Warona,

I am also facing the same issue while a replication the material from ECC system.

I know that you did this 6 years before, is there any chance you remember the exact change you did to avoid this issue.

Thanks,

Ankur

[Former Member]

Hi. Check the weight fields on your material master using MM02.

The net weight must not be greater than the gross weight, and if you key a material master in then you can not enter data like this.

Some data loads will bypass this validation though, that is how you can end up with invalid materials.

Regards,

Dave.