I must to activate the material load queues manually

[Former Member]

Hello to all,

About initial and delta material loads from R/3 to SRM. All is correct but it is necessary to go to smq2 and activate the queue manually. It must exist a customizing to do it automatic. Does someone know it?

Rewards will be paid with 10 points.

Thanks in advance.

Nacho

[Former Member · Accepted solution]

Hi Nacho,

It should automatic. If not, use transaction SMQR for queue regstn.

Regards,

Prashant

[Former Member]

what I have seen is that if any of the entry in the queue sequence is pending because of some error (eg. RFC issue)

then that entry is locked and corresponding error is shown in queues.

When you correct the cause of error (eg RFC is set correct)

you need to activated the queue and refresh so that the pending entries are posted

BR

Dinesh

[Former Member]

Hello,

Some answer there weren't very helpful but 2 points for the attempt sounds fair.

The correct answer was inscribe the queue on transaction SMQR

Thanks to all.

Nacho

[imthiaz_ahmed]

By default, when you make setting in Trx MW_MODE, the queues get activated automatically.

Regards, IA

[Former Member]

Hi,

In the backend R/3 system, check the outbound queue in transaction SMQ1. For Queue name, enter the correct queue name, and choose Execute to display the queue. If the queue is locked, try to release the lock on it and to activate it. If the queue disappears after you select Refresh, the download process has proceeded further.

Generally you dont need to actiavte in SMQ2 in SRM.But check the inbound queue in the Enterprise Buyer system and activate it if necessary.

BR,

Disha.