Testing of scenario.

[former_member437549]

Hi,

I need a clarification regarding the testing of a scenario.

Can we test a scenario in ID. and how?

tell me the procedure how to test it.

thanks

siva.

[Former Member · Accepted solution]

Hi,

You can access the test tool in the Integration Builder by navigating the menu path Tools-> test configuration....

Thanks,

Madhu

[Former Member]

HI,

Go to IR --> Mapping (Test tab)

Enter some test values in the outbound interface and copy the xml format of that (payload)

Go to --> ID

Tools ---> Test Configuration

Here you provide all the details like Sender / Receiver System . Sender (Outbound Interface)

In the payload area , paste the xml that we have copied form the IR mapping.

left press the red tab with down arrow mark to execute the scenario, if every step is fine it would give a green tick if not if would higlight with red and display the error below.

rwd points if useful

rgds

srini

[Former Member]

Hi,

You will test the mapping in ID. For testing the complete scenario you will do in sxmb_moni pay load check input and output xml files. You will receive out put after reaching the data from sender system to XI.

Thanks,

RamuV

[Former Member]

Hi,

Go to Tools tab -> Test Configuration.

Mention the sender and receiver's service & namespace.

Extract the payload from sxmb_moni and paste it in Test configuration.

Then, run the scenario using F5.

Regards,

Geetha J.

[Former Member]

Hi,

1)For design part, you will be testing the interface in the test tab itself with all possible values/conditions etc. Here, you wl get to know, how the data is getting transformed etc.

2)For configuration part, you can test from Tools -> Test Configuration by providing the required information.

3)For End-to-End Scenario try to trigger the data from source and check for the response

Regards,

Soumya