Message Split - Multi receiver - Different mappings

[Former Member]

Hello Friends,

we get different mapping results in integration Repository Mapping tool and Integration Directory test configuration.

Mapping is working fine with mapping test tool in Integration Repository.

Link:[Screenshot1|http://koekce.com/XI/pics/IR.PNG]

In the receiver Determination we use the condition editor.

Link:[Screenshot2|http://koekce.com/XI/pics/id2.PNG]

Test configuration in the ID displays no errors but the mapping result itu2019s different.

Link:[Screenshot3|http://koekce.com/XI/pics/id4.PNG]

Please suggest me in this regard.

Thanks in advance.

[Former Member · Accepted solution]

Try putting the value of TSM and TSH within single quotes in the condtions editor.

BR

Sameer

[Former Member · Accepted solution]

We have checked each and every steps again, the problem was on Interface determination, but after select the correct inbound interface with interface mapping we get this error on test config tool

[Screenshot|www.koekce.com/XI/pics/test.PNG]

is'nt share informations about error!!!

Seems very strange. Please give your expert advice on this!

[Former Member · Accepted solution]

Hi,

I am not able to see any error message in the attached screen shot.Can you tell us what the error is?

Thanks,

Vijaya

[Former Member · Accepted solution]

neither do i !!! Nothing is shared!

[GabrielSagaya · Accepted solution]

Please check the use of Enhanced Interface Determination in Multimapping...

/people/jin.shin/blog/2006/02/07/multi-mapping-without-bpm--yes-it146s-possible

in that blog

1 source Message interface and 2 Target Interfaces are used in IM.

Check whether you have created 1 more target mesage interface

[GabrielSagaya]

please check sabarish reply

[Former Member]

Try clearing both caches.

which one is correct? in the IR? or ID?

[Former Member]

Message mapping in IR working fine but when we load the test data into config test tool in Integration Directory then we get this message below;

<?xml version="1.0" encoding="UTF-8" ?>

<ns0:Messages xmlns:ns0="http://sap.com/xi/XI/SplitAndMerge">

<ns0:Message1>

payload needed

</ns0:Message1>

</ns0:Messages>

[Screenshot3|http://koekce.com/XI/pics/id4.PNG]

[Former Member]

Hey

you need to play around with </ns0:Message1> and/or </ns0:Messages>

when you are doing mumtimapping as far as i can remember you need </ns0:Message1> in test tab of IR but its not required when you test in real time or in Test configuration in ID.

Or its other way round:) i can't exactly remember right now

Please try to remove </ns0:Message1> and test in ID.

Thanx

Aamir