Question IDoc-Messages

[Former Member]

Hi,

I send an IDoc-Message from R3 to XI. So, in the transaction "sxmb_moni", I see in the field "ACK. Status" following entry:

"Acknowledgement not possible"

Is it possible to disabled this entry, so that the field "ACK Status" has no entries?

Thanks.

Regards

Stefan

[Former Member]

Hi Stefan,

If you are below SP09, you can maintain entries in table IDXNOALE using SE16. Specify Port, Client of the sender and the message type.

From SP09 and above, you can use transaction IDX_NOALE. Specify Sender port and client and use the appropriate button on the top to enable or disable acknowledgments.

Hope this helps.

Regards,

Riyaz

[Former Member]

Hi,

we use NetWeaver 2004s and transaction "idx_noale" does not exist.

So, is there another posibility to disabled the "ACK. Status" in the transaction "sxmb_moni"?

Thanks.

Regards.

Stefan

[Former Member]

Hi,

idx_noale is not transaction,

Whatever version you are using , just run SE38 and give the program name IDX_NOALE and give the port and Idoc message type, and check the changes by seeing the table

IDXNOALE with the transaction SE16 - table name : IDXNOALE

you can check these info in the below link - 3.4 section

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/903a0abc-e56e-2910-51a8-9dc616df...

Regards

Chilla

[Former Member]

If IDX_NOALE does not exist, you can manually add an entry to the table IDXNOALE using SE16/SE11 etc.

Edit: IDX_NOALE is a program not transaction. so you can execute it via SE38 transaction. it is available in SAP NetWeaver '04s SPS09. Otherwise you have to manually maintain the table IDXNOALE.

Regards,

Riyaz

Edited by: Riyaz Sayyad on Jul 4, 2008 2:00 PM

[aashish_sinha]

Hi,

Try looking into this guide.

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/docs/library/uuid/f6d2d790-0201-0010-9382-b50...

Regards

Aashish Sinha

[Former Member]

To deactivate IDOC acknowledgement;

Go to txn sxmb_adm in XI.

Go to option Integration Engine Configuration in Configuration folder.

Specific configurations

Edit mode

Delete entry RUNTIME with parameter ACK_SYSTEM_FAILUER

reward points if helpfull

regards

kummari

[Former Member]

Thanks for the hint, but I have only the parameters:

engine-type and isUrl in the edit-mode.

Do you have another idea?

Thanks

Regards

Stefan

[Former Member]

can i know the engine type which you have there

[Former Member]

It's the integration engine