on 06-26-2008 2:58 PM
Hi,
I try to configure the auto-id scenario without XI.
so i created the base type matmas01 in the nwe.
the partner profils via we20 are maintained correctly.
when i try to send an idoc via we19 there is an error 51.
i try to send a material (msg type aidmatmas). in we20 as an inbound parameter I did not know which process code I should enter, so I took the UPSM for aidmatmas inbound. Which one shall I take? The configuration guide says nothing on this topic.
error msg is "function module not permitted: IDOC_INPUT_UPSMAS
Seems as it it the wrong function module for aidmatmas, but which one is the right one?
WE57 will tell you the function module name for a basic type and Message Type combination
Regards,
Ravi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
To view all the Inbound & Outbound Idoc Process codes----
Use we64
To Assign the Process codes -
Use we42
http://help.sap.com/saphelp_nw04s/helpdata/en/dc/6b805a43d711d1893e0000e8323c4f/frameset.htm
Regards
Seshagiri
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
you are configuring scenario IDOC to NWE.
idoc is coming out from ECC, so you need to configure
out bound partner profile in we20.
please check the following t.code for
outbound process code(we41).
for inbound process code (we42)
warm regards
mahesh.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.