cancel
Showing results for 
Search instead for 
Did you mean: 

Receiver Determination in BPM

Former Member
0 Kudos

Hey,

Can anyone Explain me the significance of the reciever determination step in BPM.

What i did is created a receiver type container variable.

Used it in Receiver determination step.

In the send step that is following the receiver determination step, The "Reciever From" is Set to reciever List.

The List is Empty.

In the Configuration i have to define the receiver Determination.

At runtime, when i check the receiver List it is populated with the Service mentioned in the receiver determination(in configuration)

My question is what is the significance of the receiver determination in BPM when the purpose is satisfied by the receiver determination in ID.

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

hi,

It is used for multicasting. When your receivers are to be determined dynamically, and you need to get the list of recivers inside the BPM, you use Receiver Determination.

http://help.sap.com/saphelp_nw04/helpdata/en/11/13283fd0ca8443e10000000a114084/content.htm

Thanks,

Vijaya

Former Member
0 Kudos

Receiver determination is significant when there is more than one receiver...and they are identified dynamically..and their number changes too dynamically..

thanks,

vijaya

Answers (2)

Answers (2)

Former Member
0 Kudos

Hi

Go through this help , you might know he significance of RD in BPM

http://help.sap.com/saphelp_nw70/helpdata/EN/3c/831620a4f1044dba38b370f77835cc/frameset.htm

Can pls check that whether you have defined all the receivers in the container list & then you to go and define the receivers for that particular interface...

Hope it helps...

Thanks,

vasanth

Former Member
0 Kudos

Hi,

If you do the mapping inside the BPM using Transformation step, then you need to send the Message B.

Ie. Mapped message . In this case, your Interface determination will only determine the Receiver Interface, and it will not execute the interface mapping . (if you are not providing the Interface mapping in the Interface determination).

Example is given here-

http://help.sap.com/saphelp_nw2004s/helpdata/en/14/d5283fd0ca8443e10000000a114084/content.htm

Refer simialr discussion

Thanks

swarup

Former Member
0 Kudos

Hey,

Swarup can you please elaborate on your point.