on 06-24-2008 1:23 PM
HI Frnds,
Me trying to copy one keyfigure value to other keyfigure form one plannin gversion to other.
Iam using the above t code, and the copy is fine except for few partnumbers. Ima unable to find out exactly why the copy is not ok for few partnumbers, were as in other hand its ok for other partnumbers.
Any probable causes for the above?
Thanks
krishna
check if you have CVCs with the other version you are copying into for those part numbers
are you able to load these partnumbers in a selection in the planning book when filtering by the other version?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi,
Is there any Macro for that key figure which u want to copy from another key figure?
Sujay
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
11 | |
4 | |
3 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.