how to config J2EE Server in netweaver studio

[Former Member]

Hai can one tell me how to config J2EE SERVER to my webdynpro application.

i created first web-dynpro application. in last step it is asking for server connection

i am going to window -- > Preferences --> SAP J2EE ENGINE

after that plz tell me how to get

1) message server host

2) message server port

3) system name

4) j2ee instance

5) SCS instance

These values how can i get.

plz tell me how to run succesfully my webdynpro application.?

[vijayakhanna_raman · Accepted solution]

Hi,

If WAS server is installed in ur system then J2ee will be configured there. Your message server host is the name of the system where ur WAS is installed and the port no(3600+instance name) is given by the Administrator while installing.

Get the details and go to window -- > Preferences --> SAP J2EE ENGINE enter the port and system name. Then Apply and ok.

Hope this helps u

Regards,

Vijayakhanna Raman

[Former Member · Accepted solution]

Hi,

You dont have to install anything more for this

The instance name will be 01 mostly.then 3601 will be message port

otherwise go to

http://<host name>:50000/index.html

Click on system info and check for the same

After setting up the j2ee engine go to

go to window ->show view->j2EE->j2EE engine

and see whether the nodes of engine are shown as green n NDS

If yes then you have configured the j2ee engine

Regards

Rohit

[Former Member · Accepted solution]

Hi ,

Go to window-> preferences-> j2EE engine

Click on the option that your server is installed on remote host

Give host name as starr3s

port as 3601

and see.IF it is not working open the SAP MMC and see whether it is working.All the nodes will be green if it is working .Then try to ping it from the local system

Hope this helps you

Regards

Rohit

[arun_srinivasan]

Hi

this link may be helpful.

http://<hostname>:<port no>/sap/monitoring/SystemInfo

for message server port

Port should be 5<instance num>00.

regards

arun

[Former Member]

Hi Hari,

Go for the first check box that your server is on remote host

If your server is a remote host

For message server give the name or ip address of the server

Port should be the message port number ie 3600+<instance name>

If your server is in localhost

For message server give localhost

Port should be the message port number ie 3600+<instance name>

Hope this helps you

Regards

Rohit

[Former Member]

Hai..

Thanks everyone for your replies.

my server is in local host.

address is :- http://starr3s:50000/irj/portal

i clicked on radio button

It is showing error "No local engine could be found"

[Former Member]

One more doubt..

Should I install any software on this server.( J2EE..or any some other )

Please help me.

This is my first web dynpro application.

Thanks a lot !!

[Former Member]

Hi,

http://<hostname>:<port no>/sap/monitoring/SystemInfo

In this page you wil have all the system information..

The port no will usually be 50000.

Web AS Java is sufficient.. no other components are necessary for running the web dynrpo application.

Check this discussion !

Regards

Bharathwaj

Message was edited by: Bharathwaj R