on 06-12-2008 11:53 AM
Hi
can anyone tell me
whats the processing routine used for medium ALE.
is it ::logsys or ALE_PROCESSING for program RNASTED.
thanks
its very urgent, pls help me in rectifying it soon
Hi,
Can you please give some more clarification about your doubt
refer this link
http://help.sap.com/saphelp_47x200/helpdata/en/c8/198afa43b111d1896f0000e8322d00/frameset.htm
Thanks
Swarup
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi thanks for the replies.
Actually i am sending PO from MM to XI.
But as per my lknowledge i hav done all the configurations fine.
But still when i am saving my PO by giving configurations::
1. output type--NEU
2. medium ALE
3. Partner Function LS
4. Partner XICLNTXXXX --this is the name of partner profile maintened.
5.also hav configured correct values against NEU (processing routines,medium definition, etc)
but i after i am saving PO in me21n i am seeing err:: NO communication medium defined for medium A
so was checking the program & routines config under NEU-->ALE type
wud appreciate replies urgently as hav stuck up in this issue..
thanks a lot
regards
Hi,
R/3 Side:
1. SM59 - Create & test RFC Configuration
2. WE21 - Create a tRFC Port in R/3 & give the RFC destination(logical name of XI)
3. WE20 - Create the partner profile for the partner type LS. Add the Outbound parameters, Message Type ORDERS, give the above created Receiver Port(tRFC).
4. Output Mode-choose radio button Transfer Idoc Immed.
5. Give the IDoc type - ORDERS05 (for version ECC 6.0).
XI Side:
1. SM59 - Create & test RFC Configuration
2. T.Code-IDX1, create the port, give R/3 client, give R/3 logical system as RFC Destination.
3. T.Code-IDX2, add the IDoc ORDERS05, for the above port.
R/3 Side:
1. Check in T.Code NACE, for output type NEU, for Medium, A Distribution ALE, Program RSNASTED & Form Routine ALE_PROCESSING is mentioned or not.
2. Create a PO in ME21N, before saving, in Messages, select the output type NEU, for Medium A, in further data, selct send immed.when saving, then SAVE the PO.
3. WE05 - Observe the created IDoc & the control record.
XI Side:
1. Create a scenario for imported IDoc-ORDERS05. Activate.
1. IDX5 - Check XML Messages
Regards,
Balaji
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Yes,
Program RSNASTED
Form Routine ALE_PROCESSING.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
76 | |
9 | |
8 | |
7 | |
6 | |
5 | |
5 | |
5 | |
5 | |
5 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.