on 06-10-2008 4:32 PM
Hello.
Can someone of you tell me what the reasons are that sometimes the firing of a outbound plug don't do the navigation?
Many thanks,
Mathias
Hello
Thanks: It was a problem deep in my application: A message with CANCEL_NAVIGATION flag was causing this problem.
Regards,
Mathias
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
In your window, check if the Plugs have been linked properly. The outbound plug should be linked to the proper inbound plug.
Shruthi R
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
"Sometimes" means that the navigation works succesfuly atleast once. Then it has something to do with your code itself. make sure that the control goes to FIRE_PLUG Coding everytime.
Regards
Raja Sekhar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Check in the window if you have created the navigation link between the views. After defining the plugs, only if the navigation link is created, the plug will be fired properly. This could have been missed, have a look.
Regards,
Nithya
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Verify if when it occurs, any exception is raised.
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.