on 06-09-2008 9:07 AM
we are running PI7 ..one file which we have reprocess not getting update in R3 side(Checked through ME23N)..its PO doc which says "Message sucessfull in Outbound side"..can any one tell me even though the messgae got processed sucess full y itsnot getting reflect on R3..
Regards
Buddhike
Hello,
go to the RFC destination that you use
to post IDOCs (from receiver IDOC adapter) - transaction SM59
and go to it's logon/secutiry tab
and check if the user which is defined over there
has the right authorizations to post idocs in R3
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hey,
Check the Idoc Status in WE05, BD87.
Also check the following settings in XI.
SM59,IDX1, IDX2.
In SM59 check for the remote connection whether successful or not.
Also refer to the following link.
/people/venugopalarao.immadisetty/blog/2007/01/24/troubleshooting-file-to-idoc-scenario-in-xi
refer to the following note.
940313
rewards points if useful.
regards,
Milan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi !
Check whether some entries are present in SMQ2 or SM58.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi,
Go to R/3 system and check at Tcode WE05 if the IDOC has been created successfully. If error is u2018"Partner profile not configured" check point 9.
Suppose IDOC did not get created at R/3 end and all the pipeline steps were successful in SXMB_MONI, then go to Tcode : IDX5 in XI and click on Transaction ID field and check the status description which explains the problem.
regards
chandra
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
81 | |
10 | |
10 | |
9 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.