Individual shipmentclubbing for different Ship to parties

[Former Member]

Dear All,

Earlier during Individual shipment (VT01N),system was allowing Ind. Shipment for two different Ship to parties (Route different).

Now the problem is resolved & changes are made. But during VT01N planning/Start shipment/End shipment buttens has to be tick.

Incase user forgets to do so system will not allow PGI further. By this time (PGI) material is loaded on Truck & to be again reloaded.

Is hard core check possible during (VT01N) Ind. Shipment? If yes how?

Please help

Regards

Suhas

Edited by: SGW on Jul 8, 2008 8:54 AM

Edited by: SGW on Jul 8, 2008 8:55 AM

[Former Member · Accepted solution]

you can make settings required using user-exit.u can maintain this such that until goods issue is done for all the deleveries in the shipment u cannot set shipment completion status.

Exit need to be found...with the help of Abaper.This situation is possible.

-Reward Points if helpful.

-Sudheer

[Former Member]

resolved

[Former Member]

can i know what exit u have used?

-Sudheer