Hi
To Send/Receive to/from XI system you have to do ALE settings as follows:-
Steps for ALE settings:-
Steps for XI
Step 1)
Goto SM59.
Create new RFC destination of type 3(Abap connection).
Give a suitable name and description.
Give the Ip address of the R3 system.
Give the system number.
Give the gateway host name and gateway service (3300 + system number).
Go to the logon security tab.
Give the lang, client, username and password.
Test connection and remote logon.
Step 2)
Goto IDX1.
Create a new port.
Give the port name.
Give the client number for the R3 system.
Select the created Rfc Destination.
Step 3)
Goto IDX2
Create a new Meta data.
Give the Idoc type.
Select the created port.
Steps for R3.
Step 1)
Goto SM59.
Create new RFC destination of type 3(Abap connection).
Give a suitable name and description.
Give the Ip address of the XI system.
Give the system number.
Give the gateway host name and gateway service (3300 + system number).
Go to the logon security tab.
Give the lang, client, username and password.
Test connection and remote logon.
Step 2)
Goto WE21.
Create a port under transactional RFC.(R3->XI)
Designate the RFC destination created in prev step.
Step 3)
Goto SALE.
Basic settings->Logical Systems->Define logical system.
Create two logical systems(one for XI and the other for R3)
Basic settings->Logical Systems->Assign logical system.
Assign the R3 logical system to respective client.
Step 4)
Goto WE20.
Partner type LS.
Create two partner profile(one for XI the other for R3).
Give the outbound or inbound message type based on the direction.
Step 5)
Goto WE19
Give the basic type and execute.
fill in the required fields.
Goto IDOC->edit control records.
Give the following values.(Receiver port,partner no.,part type and sender Partner no. and type)
Click outbound processing.
Step 6)
Go to SM58
if there are any messages then there is some error in execution.
Goto WE02.
Check the status of the IDOC.
Goto WE47.
TO decode the status code.
Step 7)
Not mandatory.
Goto BD64.
Click on Create model view.
Add message type.
Along with the ALE settings you have to configure IDoc receiver communication channel to receive IDoc from XI.
In Idoc receiver communication you can either directly give the info of your R3 system or you can create a *http type RFC destination* pointing towards your R3 system (in SM59) in XI and use it in Communicatoion Channel by selecting Http Destination.
Regards
Sami
Reward points if helpful.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.