Test

[Former Member]

Hi budys,

plz tell me,how i will test of my scenario is succefully done or not.

with warm regards.

vikash.

[Former Member]

Hi,

To test the design part,go to test tab and give some data in the source side and check the wheater the target data is correct or not..

go to tools>Test configuration>in header part specify sender service,interface,namespace and receiver service.

performing end to end testing and verifying by SXI_MONITOR or SXMB_MONI

Thanks.

Soumya.

[Former Member]

1)For design part, you will be testing the interface in the test tab itself with all possible values/conditions etc. Here, you wl get to know, how the data is getting transformed etc.

2)For configuration part, you can test from Tools -> Test Configuration by providing the required information.

3)For End-to-End Scenario try to trigger the data from source and check for the response

Note: reward points if solution found helpfull

Regards

Chandrakanth.k

[Former Member]

Hi,

We can test our Scenario in the following ways

1) Test the Mapping in Message Mapping TEST Tab

2) Test Your Configuration is correct or Not by using this Blog

/people/paul.medaille/blog/2005/06/24/test-your-xi-configuration-with-the-new-test-tool

3) And also Test the end-end scenario by placing the file in the source and check in the Target Location, whether the file came or not

Regards

Seshagiri

[Former Member]

Hi,

u can check from Integartion builder.

go to tools>Test configuration>in header part specify sender service,interface,namespace and receiver service.

copy your payload from Message mapping

note your payload will be in xml format.

click on run button

now you can check scenario is succefully done or not.

reward points if help ful.

Regards,

Pradeep A.

[Former Member]

hI,

yOU CAN TEST YOUR SCENARIO by

1. testing your mapping ,

2. performing end to end testing and verifying by SXI_MONITOR or SXMB_MONI

reward points if helpful....

PrasHAnT