on 05-15-2008 7:51 AM
This is quite a wierd error i saw in the dev system post upgrade.Hope some of you might have similar experiences.
The Client was on SP 3 upgraded to SP 6. Post this upgrade -- After launching the workflow from the Console the MDM Workflow 'Step Properties' pane is not shown which lead us to version of workflow.exe to be installed / changed
Workflow version available with us is 5.5.62.33 and MDM Server version is 5.5.62.47. will it have any impact if we install a lower version workflow
Useful replies will be suitably assigned points.
R@J
Hi,
It is mandatory to have the same Versions of Installables.You cannot use the lower version of Workflow_Install_Ver setup with the higher version of MDM Server.Though you can open the Visio but Step propertiers wont be visible.
Regards,
Jitesh Talreja
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Rajesh
We also faced the same problem and it was resolved. Steps:
1)we cannot have different version of installables.
2) Apply OSS Note 1012747 (MDM 5.5 Workflow pane is not visible after launching) if step 1 is not solving the problem.
hope this helps.
Regards-
Ravi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Point taken Jitesh, does that mean that the reverse is also true - i.e
Can we go ahead and install 5.5.62.48 when server is MDM Server version is 5.5.62.47
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
83 | |
10 | |
10 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.