on 05-13-2008 12:10 PM
Hi,
we recently apply the password policy in IDES system for testing purpose.
some one accidentally delete the TMS configuration now when we try to configure TMS configuration again in 000 client it's gives following message.
password must contain atleast one digit. and we are not able to configure TMS in 000 client.
help me to resolved this.
thanks & regards,
kinjal
Hi,
might be old password of tmsadm is wrong due to password policy , try to change the password of tmsadm in 000 client.
regards,
kaushal
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
ok do following
create tmsadm ( type communication) in 000 client.
now try to configure STMS.
if still error occurs then do following
in client other than 000 open table TMSCROUTE using SE11 and create following entry.
sysnam= ,ADMPWD
Routestring=USER
save the entry then try to configure STMS in 000.
also check Note 761637 - Login restrictions prevent TMSADM logon
regards,
kaushal
Hi,
we are faced same problem, but we got solution and solved this issue.
Go to RZ10 --> Change the following parameter values.
login/min_password_specials -
> put value --->0
login/min_password_digits--> put value->0
login/min_password_lng---> put value->6
after that restart your server.
Regards,
Anees.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi all,
I was trying to configure STMS on our dummy system
we implemented password policies that at least 8 digits long and must contain 1 number.
I was getting same error that password should contain 1 number.
I debug the program and found that for user TSMADM program sets password as PASSWORD which is not compatible with our policies thats the reason it is giving error.
I used above mentioned techniq and got success.
as mentioned below :
go to SE16
Table Name :TMSCROUTE
Check any entry exist..(for me no entry exists)
Click on new entry
System =,ADMPWD (dont forget comma)
Route=USER
and save
when I again run STMS and try to save domain
It ask me logon screen I changed client to 000 and used my SAP_ALL authorisation ID to logon it works
check SM59 for RFC set TMSADM password manually.
Regards,
Nitin Salunkhe.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.