common divsion

[Former Member]

dear all,

i have two distr. channel 10,,20, and two division 01 02 and one sls org 1000

i just want to customize without extending customer(XD01), in common divison and common distr.channel only so that material created in disrt.channel 10 should be accessible in distri.channel 20 also.

at the same time , customer created in 1000 20 01 (sales area)should be accessible to all possible sls areas(1000 10 02,) (1000 10 01,) (1000 20 01 ), (1000 20 02)

when we create va01 error like sold-to-party /material is not assigned to such.. such.. sales area should not come

in screen vor1 already setting are like below:

1000(sls org) 10 (dch) 10( dch conds) 10 (dch cust /mat)

1000(sls org)20 (dch) 20(dch conds) 20(dch cust/mat)

in screen vor2 already setting are like below:

1000(sls org) 01 (div) 01( div conds) 01 (div cust )

1000(sls org) 02 (div) 02(div conds) 02(div cust)

what is the change in setting for the above scenario .please guide as i was trying a lot couldnot execute the same.

thanks in advance .

shankar

[Former Member]

Hi,

Carry out the following changes in VOR1 & VOR2 -

In screen vor1 change settings to :

1000(sls org) 10 (dch) 10( dch conds) 10 (dch cust /mat)

1000(sls org)20 (dch) 10(dch conds) 10(dch cust/mat)

in screen vor2 change settings to:

1000(sls org) 01 (div) 01( div conds) 01 (div cust)

1000(sls org) 01 (div) 02(div conds) 01(div cust)

The above changes should allow you to meet your requirement.

REWARD POINTS IF HELPFUL

Regards

Sai

[ChengzDC]

This message was moderated.

[former_member183501]

This message was moderated.

[Former Member]

Hi

If your settings are correct in VOR1 and VOR2, Go to XD03 and enter the customer number and click on sales areas and check what combination of sales areas are popping up.

Regards