CIF Error: Setup group/key 10000427 does not exist

[Former Member]

Dear CIF-Specialists,

We observed a problem on the integration between APO and R/3.

If we want to send PPM's from R/3 to APO we have the following error-message: "Setup group/key 10000427 does not exist".

Transaction CFM1 (Create Integration Modell) ==> No problem

Transaction CFM2 (Activate Integration Modell) ==> Error!

We don't use setup groups or keys in our operations but we have created the setup keys in APO and R/3 (Transaction: /SAPAPO/CDPSC6 and OP43).

As we don't have keys in the PPM's it is normal that they don't exists.

Do you have an idea where we have to set theses Setup keys?

Can you give us an indication how we could resolve this problem?

Thank you.

Best regards,

Thomas

[Former Member · Accepted solution]

Hi Ricci,

I understand from your post that you have created Setup Groups & Keys in R/3 and APO, but you dont use them in the PPMs.

Please check if you have maintained a Setup Group/Key in the Recipe you are trying to transfer. The reason this error might be occurring is because you are using a Setup Group & Key in your Recipe, which does not exist in APO. i.e, the same Setup Group & Key has not been seperately configured in APO.

Please let me know if you have any questions.

Thanks and Regards,

Sharath Krishnan

[Former Member · Accepted solution]

Dear Sharath,

Thank you for your reply.

We dont't have setup key or group maintained in this receipt. This is the strange part on this problem.

Why does it search for a setup key if we don't want to transfer it?

I checked also the setup-keys in APO and R/3 and they are the same.

We did a copy of the test-system (where the problem occurs) some days ago. Is there a table in APO where it could have some old entries about this?

Thank you for your help.

Thomas

Edited by: Ricci Olivier on May 12, 2008 11:39 AM

[Former Member · Accepted solution]

Hello Ricci,

From your reply, I understand that you have not maintained a Setup Group and Key in the R/3 Recipe, as well as the PPM in APO.

Please could you try the following:

1. Delete the existing error Queue

2. Send the PPM to APO, as an Initial Transfer

Let me know if this works or not.

Thanks and Regards,

Sharath Krishnan

[Former Member · Accepted solution]

Dear Sharath,

We found the problem.

There was a UserExit (which I din't know..) filling the PPM with a SetupKey after sending the PPM.

So we desactivated the exit (as it is an old one and it isn't needet anymore) and it works without problems.

Thank you for your help!

Best regards from (sunny) Switzerland,

Thomas

[sumeyye_1634 · Accepted solution]

Hello,

Can you detail your solution please?

I have the same error from CURTOADV_CREATE

[Former Member]

Has anybody an Idea where we have to search for this problem?

Thank you for your help,

Thomas