Restrating the successfully processed messages------Not Working

[Former Member]

Hi All,

i have Followed this Blog and Copied that STD program to Z program After that

Commented those Two mentioned lines in the Report also and activated

/people/michal.krawczyk2/blog/2005/11/09/xi-restarting-successfully-processed-messages

While Executing the Report in Se38 by proving the Message ID, iam getting this Error

Selected message does not exist (any more)

Regards

Suman

Edited by: Suman gupta on May 9, 2008 9:49 AM

[Former Member]

Hey

>>Selected message does not exist (any more

This is the issue,you don't have that message anymore hence you can't resend it(it does not matter if its successful or un-successful).

when you normally try to send the successful message(without changing the ABAP code,you should get a message as below

"You cannot restart XML message <MessageID> with this status/type"

try to send another message and see if its successful and then modify the ABAP code and resend that successful message.

Thanx

Aamir

[Former Member]

Hi All,

Any Updates On this

Regards

Suman

[GabrielSagaya]

whether you Pasted the message GUID of one of your old messages???

[Former Member]

Hi,

message GUID is having all the Zeros only

Thsts why i gave the Message ID from one of the Successfully processed Messages in MONI

Regards

Suman

[Former Member]

Hey Suman,

I asked for correct message id because some times it happens by mistake if you are working on DEV & QA at the same time and have you have copied the message id from QA system's payload and pasted it into DEV's system report.

Just asked because it happens some time.

Regards,

Sarvesh

[Former Member]

Hi Sarvesh,

Yes, i followed Every thing in this Blog,

Can any one tried this?????

REgards

Suman

[Former Member]

are you sure the messae id which your passing to your report is correct?

[Former Member]

Hi,

Yes, I Pasted the correct Message ID only

Regards

Suman