Error after applying support patch SAPK-40009INCPRXRPM

[Former Member]

Hi all,

In our PLM system after applying support patch SAPK-40009INCPRXRPM of component CPRXRPM, release-400

we are getting some short dumps like CALL_FUNCTION_NOT_FOUND saying that OLR3_DMS_RFC_LOAD_OBJECT_LINKS function module can't found but this function module doesn't exist in the system.

plz help me in this regard.

Thanks in advance.

Regards,

Raja

[christoph_hopf]

Hi Raja,

are you actually using DMS (document management) integration on your

system? the error message appears to be caused by the fact that this

integration has been activated in cProjects customizing, but either the

customizing is faulty, or there is something missing in the R/3 backend

which you are using for DMS.

In case you do not wish to use DMS with cProjects, I would recommend

that you deactivate the relevant customizing.

In case you do wish to use DMS integration, please review the

customizing in accordance with the cProjects 4.0 Configuration Guide

(which you can obtain as an attachment to note 978997). Please pay

particular attention to the fact that the correct RFC destination has to

be entered in the customizing for object types. Even in case you are

running DMS on the same system, you will need to enter a destination

(e.g. NONE) which you have defined accordingly in your customizing for

RFC destinations.

In case all the customizing is correct, and the dump occurs

nevertheless, and if you are working with a release which is lower than

ERP 2005, it could be that you are missing the relevant plugin on your

R/3 backend system (the destination system which you have defined above

for DMS integration). I unfortunately do not know which R/3 release is

used in your backend system: in case it is 470 or ERP 2004, then you

need to install a plugin before you can use DMS integration. You can

check if the function OLR3_DMS_RFC_LOAD_OBJECT_LINKS is present in your

R/3 system. If it is not present, you have probably not installed the

plugin in that system. If so, you need to install the relevant R/3

Plug-In (e.g. for ERP 2004 this is PI 2004.1, SP01 or higher), which you

can get for free in the SAP Service Marketplace

(http://service.sap.com/).

Best regards,

Christoph

P.S.: Please reward points for useful information.