Inspection lot settings for customer order returns

[Former Member]

Hi

The course material for CS states the following :-

+++++++++++++++++++++++++++++++++++++++

The serviceable item undergoes a technical check when the goods receipt is

Posted(repair orders) . You can use inspection lots in Quality Management in the technical check. The system automatically generates an inspection lot for the technical check for a returns goods receipt. <The system does this if you have made the corresponding settings in the material master of the serviceable item.>

+++++++++++++++++++++++++++++++++++++++

what settings are required & where in the material master ?

Thanks

Edited by: Isabelle Britten on May 7, 2008 12:08 PM

[former_member42744 · Accepted solution]

You must have the 05 inspection type activated in the material master. You'll find this in the QM view of the material. Click on the button labelled "insp. setup".

In the next screen add inspection type 05. Make sure the "Active" box is clicked on at the end of the record line.

Craig