cancel
Showing results for 
Search instead for 
Did you mean: 

messages are not showing in the moni

Former Member
0 Kudos

hi.....

i am doing rfc - soap scenario, in the sender communication channel monitoring it was showing success, in the receiver communication channel monitoring it was showing status is Yellow colour (Channel Started but inactive) and not found any messages in SXMB_MONI.

pls suggest me how can i rectify this type error...

regards,

Pasi

Accepted Solutions (1)

Accepted Solutions (1)

GabrielSagaya
Active Contributor
0 Kudos

please check the following link

[original link is broken]

/people/michal.krawczyk2/blog/2005/05/10/xi-i-cannot-see-some-of-my-messages-in-the-sxmbmoni

/people/prasadbabu.nemalikanti3/blog/2006/02/13/configuration-of-a-central-integration-server

Answers (3)

Answers (3)

Former Member
0 Kudos

Hi Pasi

In case your scenario is synchronous

Please perform this:

Synchronous messages are not persisted on the Integration server unless logging is switched on in SXMB_ADM Tcode(Specific Configuration->RUNTIME(Category)->LOGGING_SYNC(Parameters)).

That's the reason you couldn't find SYNCHRONOUS

Make sure that you have all entries in SXMB_ADM According to this blog shown

/people/prasadbabu.nemalikanti3/blog/2006/02/13/configuration-of-a-central-integration-server

Regards

Abhishek Mahajan

**Please reward points if helpful***

Former Member
0 Kudos

Hi,

Hi,

Here you need to set the Trace level for SXMB_MONi

switch the logging and the trace on. SXMB_ADM, conf integration engine, Parameter RUNTIME: LOGGING, LOGGING_SYNC, TRACE

Follow below steps

Goto SXMB_ADM--->Integration Engine configuration -


>Specific Configuration ---> Set the LOGGING & LOGGING_SYNC current value as 1.

RUNTIME LOGGING 1

RUNTIME TRACE_LEVEL 3

Normally with Quality or Production these kind of settings are maintained to avoid the unwanted logs in SXMB_MONI.

Refer

/people/michal.krawczyk2/blog/2005/05/10/xi-i-cannot-see-some-of-my-messages-in-the-sxmbmoni

Regards,

Swati

sunil_singh13
Active Contributor
0 Kudos

Hi Pasi ,

Make Sure that your Receiver Channel is Active.

Try to test the Same using Test Configuration available in ID

Tools->Test Configuration

You will get the answer to your Problem

Thanks

Sunil Singh

Reward Points If Helpful

Former Member
0 Kudos

Hi,

if you are Using Sync Scenario use this Blog

/people/michal.krawczyk2/blog/2005/05/10/xi-i-cannot-see-some-of-my-messages-in-the-sxmbmoni

Regards

Seshagiri