Sender Communication Channel Monitoring Error

[Former Member]

Hi....Experts,

i am doing rfc-soap scenario synchronous . this is B2B scenario, under party i created business services, under this created 2 communication channels. in RWB, Communication Channel monitoring i am getting this error at sender side..

Error in processing caused by: com.sap.aii.af.rfc.afcommunication.RfcAFWException: only partyless services are supported but party : xxxxx is set for service sender business service name and sender CC name..

pls suggest me how can i rectify these errors..

• for helpful answers i will give points*********

regards,

Pasi.

Edited by: pasi s on May 5, 2008 8:35 AM

Edited by: pasi s on May 5, 2008 8:40 AM

[Former Member · Accepted solution]

Hi,

R u using R3 system for RFc. then in this case u need to use the business system.

Can u tell me hwat r u using for RFC.

chirag

[Former Member · Accepted solution]

Hi...Charig,

thank u,

i am using R/3 system for RFC, i created the sender business service for this service i selected sap service under other attributes.

if am wrong ?

pls correct me...

regards,

Pasi

[Former Member · Accepted solution]

Hi Pasi,

As i have told you i my earlier post, you have use the same business service(Sender service) every where and also while creating the communication channel....

Regards

Sai

[Former Member · Accepted solution]

Hi...Sai,

thank u for ur response,

i am using sap system at sender side and target side third party system , how it is posible to use the same business service at both sides..

pls suggest me..

regards,

Pasi

[Former Member · Accepted solution]

Hi,

Create Party and Under that

Use Business system at Sender For RFC

Use Business Service at Receiver side for SOAP

Regards

Seshagiri

[Former Member · Accepted solution]

Hi Pasi,

I am not saying that you use the same service at both sides,

I am saying you to use the respective services at sender and Recevier side .as both are different.............

I think you have created the both communication channels under the same service(Sender or Recevier).........instead you have the use the respective serives for creating channels and use it accordingly...........................

So kindly check this with your senario.........

Regards

Sai

[Former Member · Accepted solution]

Hi..Seshagiri,

i tried like this also under party,

Business system at Sender For RFC

Business Service at Receiver side for SOAP

i am getting same error...

pls suggest me...

regards,

Pasi

[Former Member · Accepted solution]

Pasi,

Business systems with RFC or IDOC adapters can not be assigned to a XI party ...

I suggest (re)creating BS with such channel without assigned party

Rgds

Chris

[Former Member]

Hi Pasi,

Check if you are using the same business service (under which u have created the Channels) at sender side in configuration.

You have to use the same business serivce for sender under which your communication channels are created...................

Or

Create a sender communication channel in the service that u have used at sender side.............

So i think in your case there is a mismatch of using the diff sender service at diff stages.............

Hope this will solve your problem

Thanks

Sai

PS: kindly reward points if helpful