reset inspection plan after results recording

[Former Member]

Dear all,

i had one problem to be cleared, if u can please solve it.

My problem is i have assigned wrong inspection plan for one insp. lot, and i have recorded results and saved. My question is there any provision that i can reset the other inspection plan for that particular lot and record resullts again.

[Former Member · Accepted solution]

If you have already done results recording the the status changes to INSP.Once this status is reached you cannot reset theinspection plan.You will get the message saying inspectinlot is still active.If the status was REL then u can reset Inspeciton plan by going to change lot-sample reset.Sorry ,as far as i know this cannot be done .

Experts ,any input on this please

regards,

Naik

[Former Member]

Hi Vijaya,

Mr. Naik is correct

even though for more satisfaction you can help document

Gothrough

help.sap.com - Quality Management- quality inspection-inspection lot creation - creation of sample size

Hope this will help you at some extent

SADAN

[former_member698542]

Hi Vijay,

Goto QA11/QA12 Change Udage Decision enter the inspection lot number and select Usage Decision -->Functions -->Cancel Lot.

Then cancel the Material Document by which the Inspection lot was created.

Then make the GR and new lot will be generated. Then assign the Inspection Plan, Results Recording.

Thanks and regards

Murugesan