04-17-2008 11:27 AM
Hi all !
What's the difference b/w Parellel processing and Mass processing? Which one is bettter?
When do we use them?
Replies are most welcome.
With Rgds
Sunil
04-17-2008 11:51 AM
Hello,
SAP provides lot of mass processing programs like FPMA, FPVB, FPCOPARA, FPY1...etc...all these programs processes numerous contract accounts in mass...at a time and post documents, generate correspondence etc...
where parallel processing is splitting the contract accounts and processing at a time so that there shall not be any performance issue
The aim of parallel mass processing is to shorten processing times by:
Dividing up processes
Processing the dataset in parallel
You create intervals in the varaint for Parallel processing.
Parallel processing is always better ...and suggested mode
Hope this is helpful
Rgds
Rajendra
04-17-2008 1:13 PM
Hi Rajen !
Kn U Pl. xplain how 2 create intervals in the Varaint for Parallel processing. Is that variant used in Rate in Billing Master data ?
Again thnx in adv.
Rgds
Sunil
04-17-2008 1:25 PM
Hello Sunil,
For every mass program there would be Technical settings tab strip. Say take the ex of 'FPMA'. Assuming that you have customers from 1-100
In side the technical settings tab stip,
you can create a variant and inside you spilt the customers like
1-25
26-50
51-75
75-100
Save the variant. Now run the FPMA as usual.
Hope this helps
Rgds
Rajendra