Regarding Decimals in UOM
HI all,
I have created a new UOM in CUNI and my requirement is to assign the decimal places to the UOM. When I specify the decimals places as 2 while creating a new UOM, the system some how not talking the decimals and when ever I enter the value in decimals in material master the system is not allowing and thrwoing an error " Decimal places are not permitted" with "Message no. 00011".
Your valuable comments is highly appreciated.
Regards,
Shane.
Former Member replied
Hi Shane,
System is not allowing decimal places, as SAP indicates by alternate UOM as
eg 1pc = 1.43 inches
SAP permitted as
100 pc = 143 inches
this is the same as you divided the 143/100 (inches)
hope this clear your doubt.
Regards,
Maia