on 11-16-2005 3:54 AM
Hi,
I have two JCos with the same name defined. How do I remove one of them?
Clicking on the 'Remove' button is not helping me, because when I do that, the JCo only gets disabled, but still remains in the table. I want to eliminate the entire row of the JCo from the table.
Any pointers on how to go about this?
Thanks and Regards
Reena
Hi Reena,
Just Remove the <b>JCO reference</b> from the project and deploy it again. The destinations will vanish from the table.
The following are the steps to remove the JCC refernce from a project
1.Right click the project in the Web dynpro explorer and select properties from the context menu.
2.Select "WEB DYNPRO REFERENCES" from the list available in the left side of the Properties pop up
3. Choose the "JCO References" tab
4.Select the destinations that you want to delete and click "delete" button
5.Choose Ok.
Finally re-ploy the project and run it again. You'll see that the content administrator will not have the destination that you've just removed
Hope this helps,
Bala
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi
thats ok as the one that is enabled only will be taken. In any case i am surprised at how did it allow you to create 2 jco connection with the same name. Anyway disabling it makes it non usable :).
regards
Ravi
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
25 | |
12 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.