Form is not getting printted.

[Former Member]

Hi Guru's,

In the Tcode MB1A the form is not getting printed when we post the entry.

the output type is WA01.

When i save the entry i get a message below that " profitability segment is derived again.

reg,

archana

[former_member609120]

check is TCode NACE, if the form name and print program is specified against the transaction you are running

[Former Member]

yes it is mentioned.

what next?

Archana

[Former Member]

Hi,

i think your application type Is ME

And Output Type is WA01.

Check the Driver Program Name,Medium

And Smartform name Against it.

Regards

Sandipan

[Former Member]

Hi,

The details are as below......

Driver Prog Name : SAPM07DR

MEDIUM : Print Output

FOrm name : wa_scheinvers1

what else should i chk.

Regards,

Archana

[Former Member]

hi

goto this include MM07MFB9_BUCHEN_AUSFUEHREN

keep debugger DESCRIBE TABLE xnast LINES index_x.

in this include and check for which o/p type its picking then u assign the form in nace with standard print ptogram program

if it is for Warehouse management set the config in OMNU and also create condition records for the same o/p type

hope this would help u

Regards,

Venkat

Edited by: venkatakrishnan Parthsarathy on Apr 14, 2008 11:28 AM