on 11-10-2005 12:00 PM
Hi Guys,
On <b><u>run time</u></b> in a PhaseInticator control there are 2 buttons for moving
Can somebody explain me how can I use these buttons.
Evgeny
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Evgeny,
No example / tutorial found but a link which mite be usefull.
Best regards,
Dharmi
As already explained correctly, these buttons are for paging if there is not enough space to show all phases.
You cannot add actions to these buttons.
Armin
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Evgeny,
Those two buttons are basically provided as paginators to move between the set of phases. If the no: of phases in the phaseindicator is more than what can be shown within the current width of the Indicator, then the phases will be divided and shown in sets. These buttons are provided to move between these sets of phases. So these buttons will be active only of the no: of phases is more than what can be shown at a time by the indicator.
Hope this helps,
Best Regards,
Nibu.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
80 | |
24 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.