inspection point in SAP QM

[Former Member]

Dear Sir

My query is related to SAP-QM

1,How to define INSPECTION POINT in Inspection planning?

2.Where is default setting of Inspection point like at Plant level & material level?

3. If inspection point of material is changed in Tasklist and a new inspection lot is generated then it again reflect both the Inspection point (the new one & the old one).So how to aviod this problem so that it shows only the new inspection pont at the time of Result recoding.

[Former Member]

Hi,

Ref the link below for some info related to Inspection points.

http://help.sap.com/erp2005_ehp_03/helpdata/EN/b5/c4db38a91b11d1bd610000e829fdb3/frameset.htm

Regards

K.M.Arun

[former_member16241]

Hello Alpana,

question 1 How to define INSPECTION POINT in Inspection planning?

In the transaction QP01 or QP02 you can define an inspection point at header level.

This can also be done for production plans and process instructions.

The inspection point definition is done in the customizing of the Quality planning.

question 2 Where is default setting of Inspection point like at Plant level

This can be found under the customizing point Basic settings in QM.

Using the settings at plant level it is possible to define inspection points at plant level.

If you want to use the setting at material level then this would be done in the inspection plan.

question 3 If inspection point of material is changed in Tasklist and a new inspection lot is generated then it again reflect both the Inspection point?

The changing of inspection points is not possible (Inspection point definition)

The changing of inspection points in inspection plans is not recommended create a new plan in this case.

I hope that this information helps you resolve your issue.

Regards

Isabelle