on 03-28-2008 9:47 AM
I want to do the automatic valuation of the MIC (as accepted or rejected) depending on the results recorded.How is it possible?
Hi,
Maintain following -
1) For the sampling procedure, maintain the valuation type which does not include manual valuation.
2) In the inspection plan, maintain the control indicator as sampling procedure required & assign this sampling scheme to the inspection plan.
3) If the inspection characteristics is quantitative, then maintain the target value, upper limit & lower limit.
4) If the inspection characteristics is qualitative, maintain the catalgue & code groups & codes for the inspection plan. (Maintain the acceptable & rejected codes in Selected Sets before this).
5) Based on the above settings, system will accept or reject the characteristics based on the recorded results or selected code in the inspection lot.
Regards,
Prashant
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sandip,
Goto to material master in that QM view, in inspection setup choose respective type and in details activate Automatic UD check box, it should work.
Thanks an regards
Murugesan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.