Vault Configuration

[Former Member]

Hi Gurus,

I was trying to configure the VAULT for DVA with the following steps.

1) Maintained the Global Settings:

Checked the "DVA active"

DVA User: User1

Password: 1234

2)Defined Number Ranges for Vaults

3) Defined data carrier type "vault"

a) Define vault: Type: ZA, Description: Vault1, Online checkbox: checked.

b) Define vault: Vault Path:
absyer1\project\1s\

c) DVAcomputer: Blank

Saved the configuration on the SPRO side.

4) Created the DIR and attached the original file: docA from my c drive.

5) Now Checked_In into the vault1. The lock icon is in locked status.

-

---

Problems:

1) I cannot see any internal number assignment to the file I checked in.

2) I cannot find the file docA on the server"absyer1"

3) I can find the file saved into my temp folder.

Question:

1) Is this the way to configure the vault?

2) If I am missing any steps?

3) Why cannot I see the system assigned internal#?

4) Why cannot I find the file saved to my vault?

POINTS AWAITING YOUR REPLY.

Thanks,

Paddy.

[Former Member]

Hi Paddy,

The step which you have followed is very much correct.

For cross check you follow below given link it may help you and follow the procedure as per given link hope you come with solution.

http://help.sap.com/saphelp_40b/helpdata/en/c1/1c281143c711d1893e0000e8323c4f/content.htm

If it helps you please reward me the points.

Thanks!

Regards,

Seema Pilankar.

[Former Member]

Hi Seema,

Thanks for your reply. I did have the link which u have sent me. But my question is about ..

1) Why I am not able to find the file which I have check_in into the vault of the network server. The same file gets checked in

my temp folder of the c drive.

2) Where should I be using the global settings for the user and password.

3) How do the numbering system works for the vault? When you say that the system assigns a iinternal number to the file which is invisible.

Thanks in advance,

Paddy.

[Former Member]

Any updates Gurus for my questions?