Display of Unit of Measure in planning book

[Former Member]

Hi Gurus,

I maintained UoM as EA in planning area & base unit of measure for product is CT.

I also maintained relationship between EA & CT.

Now planning book shows as unit CT in display, but I want it as EA.

So which are the settings so that UoM display for that key figure in planning book as EA (Planning area UoM)

Thanks & regards

Yogendra

[Former Member]

Hi,

Also I already tried following settings chage , but still problem exists.

Transaction: /sapapo/msdp_admin

Goto the Key Figures Tab> Details> UoM check box against Key figure

regards

Yogendra

[srinivas_krishnamoorthy]

The checkbox in /sapapo/msdp_admin should be unchecked. If you check that then base UoM will be used.

if this does not work (i dont see why it should not), then also try go to transaction /sapapo/sdpuset and set the UoM at data view level or selection ID level.

[Former Member]

you mean its unchecked i hope if you want PA unit of measure

also is this happening for all KF?

check the PB design for "Unit of Measure from Product Master" - This is in the KF attribute tab -

If you set this indicator, products in interactive planning are displayed in their base unit of measure as opposed to the base unit of measure of the planning area. Key figures are still saved in the base unit of measure of the planning area