Problem during the XI Post Installation in XI 3.0

[Former Member]

Hi,

I have completed the XI Installation and doing the post installation activities in 3.0.

When i try to create the RFC Destinations using SM59, I am getting the following error for

INTEGRATION_DIRECTORY_HMI

After completing the technical details and entered into Logondata/security tab.

I was choosed as SAP Basic Authentication, then immediately i got the following Error.

SSL Client PSE DFAULT does not exists.

And all the Logon data details fields are not editable.

Please let me know what went wrong and the possible solution.

Thanks and Regards,

Sekar

[Former Member · Accepted solution]

Hi,

I think for your post installation steps , its better to use the Template installer to get it be done automatically all these settigs

Regards

Seshagiri

[Former Member]

hai check the below links

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/docs/library/uuid/ac6de690-0201-0010-54ac-892...

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/2498bf90-0201-0010-4884-83568752...

https://www.sdn.sap.com/irj/sdn/go/portal/prtroot/docs/library/uuid/a5550de0-0701-0010-a8b4-9fd433a0...

note: reward points if found helpfull

regards

chandrakanth

[Former Member]

Hi Sekar

Yes its a better option that you should use template installer

and remember the point that template installer runs only once and if this aborts in middle then it can't be restarted manually

So first make the value of required parameter high (say 500) in ABAP table and then start template installer

Rest you can follow post installation step given in the installer guide.

I did this installation with the help of this guide successsfully

You can find it on marketplace web.

Regards

Sandeep

PS reward points if helpful

[Former Member]

Hi Sandeep,

Is it possible to use the template installer in XI 3.0 ?

Please send me the link for the required document which i will follow for the Post Installation.

Thanks and Regards,

Sekar

[Former Member]

Hi All,

Thanks for the useful Information.

I have installed the Netweaver PI 7.0 and configured the post installation activities using Template Installer.

Regards,

Sekar