QA16

[Former Member]

Dea QM Gurus,

I wish to do mass UD using T. Code: QA16, but no results are displayed in layout. But if I see same pending Inspection lots, system shows list of pending without UD.

i checked for Filters and other alternatives also but facing no results problem in QA16.

Pls comment on same.

[Former Member · Accepted solution]

Hi,

Check for the follwoing condions for Auto UD.

Characteristic processing is completed.for all - i.e. Status 5

No characteristics have been rejected.

No defects have been recorded.

Also check the following thread , you may get some input.

Regards

K.M.Arun

[Former Member]

Hi,

Whehe u have set any period range for selection, then try by removing it.

Amol