on 03-19-2008 8:09 PM
I am unable to reject two batches..it shows 'no inventory exsists for this material'
Usage Decision TCode gives me the following error:
Deficit Batch restricted
Can you please tell me, what might be the probable reason?
Thanks
Well.. it's basically telling you it can't find the material in the stock category it is looking for it in.
So, to resolve this, first find out where the batches really are.
Get the actual batch numbers from the inspection lots and run MMBE to see where the material is and what the status of the batch is, restricted or unrestricted.
You must then figure out where is the UD transaction looking for the material? You can check this by looking in config and the looking at the settings for the inventory posting. You should see 3 movement types for the reject posting line. One for QI, one for unrestricted and one for blocked.
What you need to do, is a) get the batch inventory into the proper inventory bucket. This might be as simple as unrestricting the batch. b) if you can't get the material where it needs to be, you might be able to temporarily change the movement type used for the reject postings. Then change it back to what it should be once you rejected the material.
Hope this helps.
Craig
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Using transaction code MMBE pl.check the stock location,
problem is not available in quality inspection.
Regards,
krish
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.