Where we can see Outbound Payload

[Former Member]

Hi,

I have a scenario IDOC to File

When i posted the IDOC from R/3 to XI , iam able to se the Inbound Payload in MONI

Similarly where can i see the Outbound Payload that is after all the message processing.

To be precise the Output XML File

Regards

Suman

[Former Member · Accepted solution]

Hi

Go to Runtime Workbench>>Select Message Monitoring

>>>select date>select your sender interface>

click ok>> then open link> u can select payload from drop donwn just below the SOAP>

[Former Member · Accepted solution]

Hi,

Can't we see in the MONI itself( ABAP Stack)

We are Executing the whole process at ABAP Stack and have to see the Oubound payload in the JAVA stack.????

Regards

Suman

[Former Member · Accepted solution]

Try using the Tcode IDX5.

[rodrigoalejandro_pertierr · Accepted solution]

hi

you can see the outbound payload in SXI_MONITOR.

but, first you must go to SXMB_ADM>integration engine configuration>change global data-->set the value for TRACE_LAVEL to 3.

later in SXI_MONITOR you will have, per scenario, a line for inbound message and a line for outbound message.

if i am not wrong, if you set the trace level to 2 you can see the outbound payload in same place you see the inbound message, you have to go to Message mapping or integration mapping i dont remember, but in any of this option you going to see the outbound payload

/people/michal.krawczyk2/blog/2005/05/10/xi-i-cannot-see-some-of-my-messages-in-the-sxmbmoni

Thanks

Rodrigo

pd:rewards points if useful

Edited by: Rodrigo Pertierra on Mar 18, 2008 9:11 AM

[Former Member]

hi,

you can see the payload of outbound message RWB.

go to runtime work bench ->message monitoring->

give the receiver interface name,

the following message appeared there. select the message ,the audit log for the message will appeare.

Now go to message content tab and select message pay load.

regards,

navneet

[GabrielSagaya]

/people/shilpa.kchakravarthy/blog/2008/01/17/xml-validation

/people/riyaz.sayyad/blog/2006/12/08/dealing-with-errors-on-the-outbound-side

[ChadRichardson]

When you configure the outbound communication channel you tell XI where to create the file and what to call it. If you haven't configured the channel yet then XI won't know where to stick it.

[Former Member]

Heloo,

You please try to understand the problem first.

Dont Use this type of English. no one will understand

Regards

Suman