Error while loading data into 0pur_c03 using 2lis_02_scl

[Former Member]

Hi,

While trying to load data into 0pur_c03 by using Data Source 2lis_02_scl from R/3 the error message "The material 100 does not exist or not active" is being displayed. I have loaded master data for 0Material and performed change Run also.Still the problem is not resolved.Please suggest in resolving this issue.

Regards,

Hari Prasad B.

[Former Member]

I have the same problem in my system and i found that the material XXXXX had movements.....sales documents and more but in certain moment it material was deleted in R3 and it is not loaded into 0MATERIAL infoobject because is marked for deletion....

If you have this error must activate the load request manually and your infocube can hold the data without any problem.....

Regards

[former_member39123]

Try to simulate the extraction in RSA3 (R/3 t-code).

Write your extractor and your material; then execute it.

If you don't see any record, the problem is in R/3 (try to see in user exit).

[Former Member]

It seems that material 100 does not exitst in master of source system.

Regards,

Mahendra

[Former Member]

Thats the problem for the error. There is no Master data 100 for material.

Either create master data in r/3 or remove the data in bw and try again.

-Sonti-

[ChandranGanesan]

Hello Hari,

First make sure that the material 100 exists in Source system in MARA table or MM03 tcode.

Thanks

Chandran