on 03-15-2008 12:05 PM
Dear Knowledge Managers,
Iam working EHS module. I am getting some difficulty "Measured Value-Reference Value Comparison "
With this method, i cannot able to compare the measured values that entered in the amounts function with the corresponding reference values in the SAP EH&S specification database.
Reference value not appearing even though it is defined in EH&S specification database.
Thanks & Regards
V.Vinoth kumar
Hi V.Vinoth kumar,
I have the same problem, 'reference value can not be found', even if I have it specified in the specification workbench. The following SAP Notes could be related to it: Note 841192 and Note 1076410. I did not implement the notes, cause of the fact the notes are not related to the current system status.
Could you let me know if you have found the solution?
Kind regards,
Roy Derks
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Vinoth,
Pls check these function module as these are going to fetch the values
CBIH_LB65_UE_MJVA_COMPUTE CBIH_LB42_UE_SRTCP_COMP
Regards,
Keshav
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Kesav,
I have added these function modules but iam getting same message " Reference value not found"
ERROR MESSAGE BELOW
*****************************************************************************************
No reference value was found
Message no. CBIH404
Diagnosis
The system attempted to read a reference value from a characteristic. This failed because there is either no value available in the set characteristic or the usage of the characteristic is not appropriate.
System Response
No reference value is determined; processing is continued.
Procedure
Enter a value in the characteristic and set the usage accordingly. For more information, see the documentation on the user exit CBIH_LB12_USEX_HAZ_GET_EPLIMIT.
*************************************************************************************
But i have mentioned the value in charactersistic SAP_EHS_1023_006_VALUE_PPM & set the usage corectly
My interest is only to fetch value in reference value field to comare with measured value.
Also i have couple of duobts.
Reference value field is the Character type.
Also characteristic SAP_EHS_1023_006_VALUE_PPM under property tree in numeric format. How it will fetch value if the format are different ?
Help pls...
Thanks & Regards
V.Vinoth kumar
Hi Vinodh,
It all depends on the type of measurement you are doing..you can either set numeric format or phrase sets; in numeric format you need set the values, you can set the reference value; SAP_EHS_1023_006_VALUE_PPM; for characteristics FM C14K_PHRASECHARACT_CHECK will help in checking those values; in your case you need to change the charectestic.. other characteristics like SAP_EHS_1023_006_VALUE_ML and SAP_EHS_1023_006_VALUE_MG are also available; tell me for which scenario you are measuring, I can help you
Regards,
Keshav
User | Count |
---|---|
91 | |
10 | |
10 | |
6 | |
5 | |
5 | |
5 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.