on 03-12-2008 11:02 AM
Hi all,
I have created a file to file scenario but when I execute it I can not see the outbound payload in the sxmb_moni and execution is successful. With other scenarios like file to idoc or idoc to file I can see the outbound payload.
Any idea?
Thanks
Diana
Plesae test your mapping in XI using test tool for the given input That will make sure that your mapping is not generaarting blank output May be u have written at end of mapping some function to about the mapping
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Is the file created in the Target directory.
and also execute the following Tcode sxmb_adm and follow the flow
integration engine configuration> Specific configuration> set TRACE_LEVEL to 3.
Also try to refresh the cache,.
Regards,
Nithiyanandam
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Diana
Kindly check your mapping
Is there any condition which is getting satisfied and according to that empty output is generated
Or better import your payload and send the message again
Thanks
Sandeep
PS: kindly reward points if helpful
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Try cache refresh and then go for sxmb_moni.
sometimes due to cache problem we are unable to see the payload
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Diana,
In Sxi_Monitor, Click on message , go inside, and in left side till call adapter check out the Payload of your message. It will show you in which step you missed the payload and check out that part in your IB or ID. That will help you to trace the exact location.
Regards
Aashish Sinha
PS : reward points if helpful
Hi,
Check in the Communication channel monitoring with respect to the sender adapter and see the status.
regards,
kishore kumar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi
go to tcode sxmb_adm>integration engine configuration> change global data--> set TRACE_LEVEL to 3
Thanks
Rodrigo
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
go to sxmb_adm> integration engine configuration>change global data and check if the variable tyte:
RUNTIME................LOGGING................0
RUNTIME................LOGGING_SYNC......0
were setted.
also go to RBW>components monitoring>Adapter Engine-->cmmunication channel monitoring.
check if you are facing any problem when you get data from receiver system.
Thanks
Rodrigo
User | Count |
---|---|
86 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.