on 10-26-2005 2:26 PM
Hi,
Iam new to BPM area. I used BPM in my scenario to
test but i was unable to find the message even in SXMB_MONI/sxmb_moni_bpe for that scenario. Is anything beforehand needed to be acitivate or configured inorder to run the BPM engine. Thanks inadvace.
Regards,
Mallikarjun.M
Check whether your sender channel picked up the message, if it did then check your receiver determination. There is no special configuration is required in the system to activate BPE, it is bundled in default installation and XI post installation steps & configuration steps are sufficient.
regards
Shravan
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
81 | |
9 | |
9 | |
7 | |
7 | |
6 | |
6 | |
6 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.